HP Stealth Shield™热障试验

保持汽车的热量或卡车的内饰可以让骑行更加愉快。新利lb快乐彩热障碍s, insulation and other heat control products significantly decrease the heat transferred to the interior of the vehicle. To show what our product line is capable of and what you can expect, we conducted a test using the HP Stealth Shield™ heat shield interior insulation and thermal-barrier material.

HP隐形盾牌is a lightweight material that feels like felt cloth and is based on the same proprietary technology and specially formulated material used in our welding blankets. It blocks heat and can even withstand direct contact with flames. At only 1/8-inch thick, HP Stealth Shield can easily fit under carpet or vinyl flooring and above the headliner. It can handle up to 1,800 degrees F of continuous heat and up to 2,000 degrees F intermittent. Its minimal thickness means HP Stealth Shield can be combined with an acoustic barrier yet not create fitment issues. And since it’s like a fabric, HP Stealth Shield will conform to any floor pan or roof panel. You use scissors to cut the material to fit, with installation being as simple as a quality spray adhesive like 3M Headliner and Fabric Adhesive to secure HP Stealth Shield in place.

To demonstrate how efficient HP Stealth Shield is and its capabilities over stock insulation, we assisted with the rehab of the interior of a 1996 Chevy Caprice. The original carpet was especially nasty and in need of at least a thorough cleaning. But with a 1996 9C1 Caprice police car to supply parts, it was decided to pitch the carpet in favor of the police car’s vinyl flooring that was in great shape and would be much easier to clean. This provided the opportunity to replace the original factory insulation with the much more efficient HP Stealth Shield.




更多:In addition to being very flammable, the factory insulation is much like a sponge, soaking up moisture and not easily drying out. When the original carpeting was removed, we found evidence that the HVAC system had leaked engine coolant onto the floor, through the carpet and into the insulation. The factory insulation then kept the moisture trapped and caused rust damage—enough that we needed to employ rust neutralizer before installing the HP Stealth Shield and new vinyl flooring. This photos shows how we immersed a section of the in water, then squeezed it like a sponge. You can see just how much water the original insulation held.

更多:然后,我们将“挤压” - HP隐形屏蔽上的“挤压”参数复制。它比工厂绝缘更少的水显着较低,这意味着如果它被弄湿它会更快地干燥,降低捕获水分和腐蚀的风险。我们实时拍摄了一个短暂的差异视频。